by 2SpecialAdmin | Nov 1, 2022
Determine theoretical rigidity of an arm of an existing pulley to make a subsequent comparison with reality.Goal: determine which tensions can actually be allowed in the materials.The found maximal tension cannot be exceeded by new products, but should be approached...
by 2SpecialAdmin | Nov 1, 2022
Cover of synthetic material (PCTG)Cyclic load by an equally divided load (1 bar pressure omnidirectional from the outside)Most important criterion: safety factor until kink larger than 2 at 45 degrees ambient temperature and after 50000 cycles of 1 minute....
by 2SpecialAdmin | Nov 1, 2022
Hot runner tip in mold gate.Thermal matter.Optimization of geometry and selection of materials with the goal of letting the temperature of the tip in the gate approach the heater temperature as closely as possible. Characteristic method of calculation:- steady state...
by 2SpecialAdmin | Nov 1, 2022
Curved metal pipe profileStatic loadImportant criterion: moving the load point to smaller than 5 mm Characteristics of the calculation method:- static linear- volume elements
